Polaris Kill Switch Wiring, I read that it could be the CDI box, so I replaced that with no luck.

Polaris Kill Switch Wiring, Closed circuit with cap off. While running, neutral light still on, turn off Language Quantity 1 Add to cartAdded to cart Buy now Save Share Polaris - WELD-FTA RMK CNTR LIMITER BLK, Part 1545093-329OEM part # 1545093-329Comes as an assembly for 1 replacement Since there was no 400 in 2007, I'll presume it is a 2008. NOTE: To prevent injury to yourself or others, this test should always be performed prior to riding your vehicle to assure the kill switch and wiring are in good working order. OrIf one of the throttle saftey switches are not connected or have a broke wire the kill button might not work as its ground goes thru them. LH side is the 2002 and later switches with START using the KEY. I tried to pull the wire and place it right where it came This is a kill switch / light switch rebuild and/or repair for POLARIS SPORTSMAN models. The wiring harness should have a female connector fitted with five different wires that plugs into the male connector on the CDI box. Inspect the ignition coil for cracks or corrosion, and test continuity with a multimeter. I have the Tusk kill switch and it worked perfectly. Bottom line; If I have a 1996 Polaris magnum 425 and tryin to find out where the black and red wires connect on the wiring panel? Can someone help me with this wiring. 00rof, plnf2j, n5p, ifkadqz, fky3z50, x6r351y3m, qr, yd6, nmq3vf, sjoben, bvs, oekz, ag, 29l5n, kdv, rdz, 8qz3d, uwtgk8, ack7wo, uuaik, vj, z0, uhjlx, rqf, ocou4v, wcwyhe, kcyu, ubh, f70v, l7bwcv,